Fully autonomous operation

Fully autonomous operation is divided into two interfaces: the “planning plot interface” and the “executing operation interface”.

Planning plot interface: divided into “my plot” and “nearby plot”.

1. My plot: Mainly step on plots, collect obstacle areas, boundary points, etc.
2. Nearby plots: mainly used for plot sharing among different users.

   Operation interface: Divided into “work to be done” and “work in progress”.

3. Pending work: The plots allocated from “My Plots” will be stored in the “Pending Work” first. After adjusting the width, speed, flow, margin and other parameters, they can be uploaded to the flight controller. Started to perform fully autonomous operations normally.
4. In operation: For plots that have started operations (in operation or completed), the operation progress information can be viewed in “In operation”. When it is necessary to continue the execution of an unfinished plot, find the plot in “Operation”, upload the route again, and continue the operation at the previous break point.