Easy mode (new)

1. Connect button

When the device is not connected, the device to be connected is displayed; when the device is connected, the electronic module information is displayed. As shown below:

2. Number of satellites

Used to display the number of satellites of the current aircraft (when RTK is used, the number of RTK stars is displayed)

3.RTK icon

Red means not connected, green means connected, and gray means not installed.

4. Remote control connection status

The upper represents the signal strength of the remote control and the remote control, and the lower represents the signal strength of the image transmission;
Green means that the remote control is connected, and gray means that it is not connected.

5. Battery display

The green S icon represents the smart battery connection, and the white represents the normal battery connection;
The upper represents the normal battery voltage, and the lower represents the smart battery voltage.

6. Work acres

7. Imitation ground radar

You can click to set parameters when connected
The bottom indicates the setting height, the green indicates that it is connected, and the gray indicates that it is not connected

8. Airplane mode

Display the real-time flight mode status of the flight (attitude, manual, AB point, full autonomy).
After clicking the icon, you can switch the flight mode: A is attitude, M is manual, AB is AB operation, M+ is M+ mode, and B is returning home.

9. List of tasks or plots

The planning plot interface displays: my plot, nearby plots;
The execution interface displays: pending job, job in progress.

10. Display “speed”, “dose”, “height”, “distance”, “area”, “velocity” and other information (the radar is connected and turned on to display the altitude of the radar)

Click the position of the “flow velocity” icon to set the spray mode:
Used to set manual spraying (spray according to the set maximum opening)
Accurate spraying (automatically set the pump opening according to the set spray volume per acre)
Linkage spray mode (the opening degree will be automatically adjusted according to different speeds)

  1. Compass
  2. Clear switch: you can clear the route track on the map
  3. Switch between normal map and satellite map
  4. Check my position and the position of the aircraft (for example, click the small icon of the aircraft, the aircraft position will immediately return to the center of the display)
  5. Parameter tuning function
  6. Image transmission display or map display, click to display the image transmission or map in full screen. Click “small bulb” to turn on the LED light on the camera.
  7. Exit the main page button
    After clicking, it will exit the main flight interface and enter the main interface of the APP.